10/18/2023 0 Comments System shock wiki interface modulatorHave E-stop switch pressed (open circuit) during configuration to avoid unexpected motionįollowing settings are constant and always required with SimuCUBE: If unsure which settings are factory defaults, then repeat firmware upgrade procedure and tick the Reset device to factory state checkbox before uploading the firmware. See also List of motors for SimuCUBE for pre-made configuration files.Ĭonfiguring motor manually Īll settings except the one mentioned here should be kept at their factory defaults. All done, proceed to Testing settings chapter.Click Save settings to drive non-volatile memory and answer yes to questions of applying settings and restarting drive afterwards.If you have pre-made configuration file made to your motor and SimuCUBE, you may follow this chapter to load it in the IONI and skip the next chapter Configuring motor. Proceed to Loading motor configuration file or Configuring motor manually chapter.Connect again into drive by choosing Connect to drive just like we did first time.Follow instructions of Granity user guide/Uploading a firmware.Download latest IONI firmware from IONI firmware releases.Upgrading IONI firmware įirst it is recommended to upgrade to the latest IONI firmware: If not, see SimuCUBE troubleshooting and Device connection troubleshooting. All others may be left unconnected.Each SimuCUBE system consists one IONI Servo & Stepper Drive that is controls the motor of Force feedback system (FFB)If everything went fine, we are now connected to IONI and change it's settings. Connections needed in this step are: AC, X1 (motor power and E-stop), X16 (encoder) and X4 (Granity USB).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |